Registering to LTE network
Before inserting the SIM card, it is necessary to disable the PIN code. You can do so by inserting the SIM to a standard cell phone. Most of the phones have the option to disable the the PIN in their settings. Here is an example from a Samsung phone. If you are not sure how to do it, please consult manual of your cell phone.
After inserting the SIM card to the 2N® LTE Verso, you can observe behaviour of the red LED diod placed under the Main Call button to verify the status of the device. Meanings of different signals are described in following table:
|Diode is flashing after boot up||2N® LTE Verso is connecting to the network||This is normal behaviour.|
|Diode is off||2N® LTE Verso is connected to the data network|
|Diode is illuminated for 5 seconds||SIM card error (SIM not inserted, PIN request enable or no active data service)||When this 5s timeout is over, another connection attempt is made and the LED starts flashing again.|
|Diode is flashing only||The LTE signal is insufficient||Check the area LTE signal coverage and antenna connection.Alternatively, use an appropriately placed external antenna. Caution – do not stick the external antenna to a metal surface!|
2N® LTE Verso includes a set of SMS commands that help you identify the device state and configure the basic mobile data connection parameters.
Send SMS in format state pwd=<password> and intercom will return information about network and signal.
Send SMS in format set pwd=<password> my2nid=<Your My2N ID> to register your 2N® LTE Verso to your Site in case you do not have My2N Security code.
You will find your My2N ID here:
You intercom will automatically appear in you account and you only need to confirm it. Bellow steps 1 to 4 are not needed if you use this SMS command.
More details about SMS commands are in the manual.
Registering the 2N® LTE Verso to My2N cloud
Enter your My2N account, go to the Site you want to register the 2N® LTE Verso, if you own various, and follow these steps:
- Go to Settings and select Where to call from.
- Select 2N IP Intercom.
- Add New Intercom.
- Fill in the Serial Number and the My2N Security Code. If you do not have the code, see the above section SMS commands.
You can find the Serial Number and My2N Security Code enclosed it the backage.
- The intercom will be seen as registered within couple of minutes.
- Meanwhile you can go ahead and add a device (or several) to be called, when the button is pressed.
Now, you can make a call towards the device by pressing the button. With this, you have finished the basic set up.
To be able to further configure 2N® LTE Verso, you need to add it to remote configuration tool:
- Go to Remote configuration section and select Add Device.
- Select the 2N® LTE Verso you have added previously to My2N cloud.
- Confirm the selection.
Click on Configure, log in and access the configuration interface of the intercom.
Now you can fully control settings of the 2N® LTE Verso.