Skip to end of metadata
Go to start of metadata

Info

Icon

This FAQ briefly describes how to connect/dissconect external LED diods to the 2N® Lift8 car unit in proper way without damaging it. Below you will find a few brief steps with photos which ilustrates the procces.

 

  1. Loosen the 4 screws marked in the picture below. It is not necessary to release them!



  2. Once the screws are loosen, you can move the front plastic plate in way that screw heads will move to the bigger holes as you can see in picture below. After that you can remove the front plate.



  3. Once the front plate is removed, you will gain access to LED diods connectors where you can connect/disconnect them.