External RFID card reader is useful when you need a secondary reader for 2N® IP Force or 2N® IP Vario, for example to open the door from inside in order to leave the building. External RFID card reader is interconnected with 2N IP Intercom via Wiegand interface. Used RFID cards must be compatible with EM4100 or EM4102 standard and work on frequency 125 kHz (9159030) or must be compatible with Mifare standard and work on frequency 13.56 MHz (9159031).
Installation and setting up procedure is the same for both version (125 kHz and 13.56 MHz) of the RFID reader.
Electrical Characteristics for 125kHz and 13.56MHz reader
- Operating Voltage range 9V up to 16V DC
- Current consumption Maximum 30 mA
- Operating frequency 125 kHz for reader with Order no: 9159030
13.56 MHz for reader with Order no: 9159031 - Read range 3 to 6 cm
- Protection standard IP68
- Output WG 26
- Max cable length up to 100m
. 2N® IP Vario
For 2N® IP Vario connect the external card reader according to pictures below. Red wire is connected to signalization bus providing card reader with +12 V power. If you use external power supply, you do not have to connect this cable.
Configuration
In WEB interface make sure to set up Wiegand 26-bit at Hardware - Card Reader.
Now when everything is set, you should be able to operate internal lock from external RFID card reader. If you enclose the card to the reader, you should see green LED which indicates the card detection.
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
2N® IP Force
For 2N® IP Force connect the external card reader according to the pictures below. Two button wires providing power supply of a card reader with +12 V power. If you use external power supply, you do not have to connect this cable.
Configuration
When the wiring is done, navigate to the web configuration menu and in Card reader -> Wiegand Interface change parameter "Interface mode" to input. By this setting you will specify that 2N IP Intercom will accept data from the external card reader.
Now when everything is set, you should be able to operate internal lock from external RFID card reader. If you enclose the card to the reader, you should see green LED which indicates the card detection.
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
2N® Verso
For 2N® IP Verso connect the external card reader according to pictures below. Red wire is connected to external power supply.
Configuration
In web interface make sure to set up Wiegand 26 bit at Hardware -> Extenders .
Now when everything is set, you should be able to operate internal lock from external RFID card reader. If you enclose the card to the reader, you should see green LED which indicates the card detection.
More product information: