Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Tested with the meter , which supporting supports pulse output (S0) and 2N® SmartCOM PRO ETH with firmware 1.13.x

...

AT^SCAMS="DEV_ADD",128,"AIN_DIN","1/PULSE/ABS","5M"              - absolute value of pulses on input 1 eachevery 5 minutes
at^scpulse2="start"                                              - enable pulse counting on input 2.
AT^SCAMS="DEV_ADD",128,"AIN_DIN","2/PULSE/REL","5M"              - relative (difference between two readouts) value of pulses on input 2 eachevery 5 minutes
Possible time intervals:                                         -  "1M", "2M", "3M", "4M", "5M", "6M", "10M", "12M", "15M", "20M", "30M", "1H", "2H", "3H", "4H", "6H", "8H", "12H", "1D"

...

AT^SCAMS="DEV_REMOVE",1                                           - Remove device from defined position

...