...
at^scwmbus=”mode”"mode",11
where “11” is mode type. SmartCom supports the following modes:
...
at^scwmbus=”sniff”"sniff"
Wait a little unless SmartCom discovers available WM-Bus equipment
...
at^scwmbus=”dev"dev_add”, “VIP”add", "VIP",81424136,0,01,07
4) Some WM-Bus equipment send encrypted messages. These messages must be decrypted by SmartCom to provide the readable data. In this case enable decrypting by parameter "1" in the following command (0 disables decryption mode)
at^scwmbus=”decrypt”"decrypt",1
Each vendor uses unique decryption key, this key must be stored in SmartCom for messages decrypting:
...
5) If you need to delete some meter device from the table just enter
at^scwmbus=
...
"dev_
...
remove",1
where “1” is position number of the meter in the table
Or delete the whole table
at^scwmbus=
...
"dev_
...
clear"
| Faq_zapati |
|---|