Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Records in LCR table are read from top to bottowbottom. When a record that matches all conditions is found than the call is going to be sent to outgoing destination specified in that record. Therefore it is important to pay attention to the order in which you have your LCR table records organizedorganised! 


From (channels/groups) - this parameter specifies where outgoing call originates. In case of Stargate or BlueTower it can be:

...

Prefix list - you must specify either one prefixlist, that the outgoing call number must match, or you can select option All prefixlists, where any outgoing call number that matches at least one prefixlist, will be routed by channel specified under Groups/TarrifsTariffs

Groups/Tarrifs Tariffs - this parameter specifies if outgoing call should go through a specifis specific GSM outgoing group (1-32), VoIP or PRI interface (NT/TE)

...

This way you have a better control over how ougoing outgoing and incoming calls are handled and routed. Plus it is possible to route incoming calls from GSM back to GSM which was not possible in older firmware version.

...

Firmware 1.20
Firmware 1.19 and older

 

Calls coming from PRI NT interface (lines 2-4) are routed based on prefix lists.

  • if there is a match in prefix list 1, the call is sent over GSM outgoing group 1
  • if there is a match in prefix list 2, the call is sent over GSM outgoing group 2
  • if dialed dialled number does not match prefix list 1 or 2, or there are no free channels in GSM outgoing group 1 or 2, the call is sent to PRI TE interface

 

Calls coming from VoIP (lines 6-8) are routed based on prefix lists:

  • if there is a match in prefix list 1, the call is sent over GSM outgoing group 1
  • if there is a match in prefix list 2, the call is sent over GSM outgoing group 2
  • if dialed dialled number does not match prefix list 1 or 2, or there are no free channels in GSM outgoing group 1 or 2, the call is sent to PRI TE interface
First you need to change Port modes to match your desired scenarion scenario (top picture above) and than you need to create 2 rules in your LCR table to match your scenario.

4) Incoming call from GSM group 2 (matching prefix list 2) will be routed back to GSM through GSM

...

outgoing group 1. Every other incoming call from GSM will be sent to PRI TE interface. Everything else is left in default.

Firmware 1.20
Firmware 1.19 and older
Sending incoming calls from GSM back to GSM was not possible
On picture above you can see how to set a scenario where all incoming calls from GSM incoming group 2
should be sent back to GSM through GSM outgoing group 1 (if dialed dialled number will match Prefix list 2)
Sending incoming calls from GSM back to GSM was not possible
Sending incoming calls from GSM back to GSM was not possible

On the picture above you can see how to set described scenario.

All calls from GSM incoming group 2 (matching prefix list 2) are sent back to GSM. 
All other calls from GSM are sent to PRI TE interface.

Sending incoming calls from GSM back to GSM was not possible