Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Firmware 1.20
Firmware 1.19 and older

 

 

In default there are 6 records which match the default setting of Port modes and LCR table from firmware 1.19 and older

You needed need to setup both Port modes and LCR table.

...

Firmware 1.20
Firmware 1.19 and older

 

Calls coming from PRI NT interface (lines 2-4) are routed based on prefix lists.

  • if there is a match in prefix list 1, the call is sent over GSM outgoing group 1
  • if there is a match in prefix list 2, the call is sent over GSM outgoing group 2
  • if dialed number does not match prefix list 1 or 2, or there are no free channels in GSM outgoing group 1 or 2, the call is sent to PRI TE interface

 

Calls coming from VoIP (lines 6-8) are routed based on prefix lists:

  • if there is a match in prefix list 1, the call is sent over GSM outgoing group 1
  • if there is a match in prefix list 2, the call is sent over GSM outgoing group 2
  • if dialed number does not match prefix list 1 or 2, or there are no free channels in GSM outgoing group 1 or 2, the call is sent to PRI TE interface
First you needed need to change Port modes to match your desired scenarion (top picture above) and than you needed need to create 2 rules in your LCR table to match your scenario.

...