Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

The 2N® Helios IP can be integrated into a Wildix VoIP PBX , which is a SIP Protocol based IP PBX. 2N® Helios IP operates as an SIP subscriber and can stream its video to the IP telephone. For No additional equipment is needed for full integration of the door intercom in the telecom system no additional equipment is needed .

Tested models:

PBX

WGW08 - WGW16 - WGW40 - WGW90 - WGW250 - WGW500 - WGW1000 - WGW5000 

...

  • Audio call
  • Video call
  • DTMF transfer

1. As a very first step configure new user in Wildix PBX. Select the PBX IP address from your WEB browser and go to section "User" (Utenti) and add a new user.

...

At the end of this procedure , and after the configuration of 2N® Helios IP (step n. 4) you can see the status of this new user as showed in the picture below:

The green led shows that 2N® Helios IP is registered on PBX. If you put your place a mouse on the "user", you can will see the information about it: name, IP address and transport type.

4.From 2N® Helios IP side go to the section "Advanced Settings" and tab "SIP Settings" over there you need to fill . Fill in "User ID" and "Password" which match matches to the "ID" and "Password" set in the Wildix  side, and “Domain”, “Proxy Address” and “Registrar Address”. See below:

To verify that you have successfully registerregistered 2N® Helios IP terminal into Wildix PBX side, go to the section "Information” in the 2N® Helios IP.

...