Versions Compared


  • This line was added.
  • This line was removed.
  • Formatting was changed.

In this FAQ you will see how to configure sending of SMS messages via SMPP feature on 2N gateways. First of all you can read a brief introduction how do these features work and after that there are several important steps which have to be met for proper settings of this feature:

    • Set the GSM gateway to send/receive SMS via SMPP
    • Define the routing rules for incoming and outgoing SMS messages
    • Check the GSM gateway SMS database´s filling capacity

This FAQ applies for following gateways:

  • 2N® BRI Lite, 2N® BRI Enterprise (2 channels)
  • 2N® VoiceBlue Next (2 or 4 channels)
  • 2N®VoiceBlue MAX (4 channels)
  • 2N® BlueTower (2 to 8 channels), 2N®StarGate (2 to 32 channels).


Note: As a very first step please make sure that the license for SMPP feature is uploaded into your 2N gateway. This license is sold as a package for 10 users (you can buy licence for 10, 20, 30, etc. users) and you can have up to 200 licensed users in the gateway. If you want to verify that you have uploaded the correct license in your gateway, go section "Management -> License key". You should see a license licenses called SMSS and SMSUx in  in the "Active" rowSMSS indicates that SMPP feature is enabled and SMSUx indicates number of licensed users where x stands for the number of licensed users this number (see the picture below). If there will not be a license for SMPP (SMSCSMSS) then you will not see tab "Messaging" on the top bar!Image Removed

Image Added

Gateway configuration

Function enabling and modules grouping